SCHLAGE BE469 UPDATE
SCHLAGE BE469 PRO

I believe the Wink Hub 2 connection to the Schlage was secure/encrypted from my research. Then joined to the Hubitat new via the process they defined for the join. Yep, the lock was reset to factory defaults. Was there maybe a setting that has to be set in the lock, that perhaps you forgot about because you’ve had the lock for so long? U reset the lock to join it to a Hubitat correct? That would be a change from before. I’m not saying any one thing here is the cause, but you’re going to need to establish a baseline with all the manufacturers recommendations first or you may not ever find the issue. Others have this lock and don’t report this issue, so you’re going to need to figure out what’s different about your installation.Īny way to move that repeater in between the lock and the hub, instead of closest to the lock? That should include another exclude, then factory reset with Alkaline batteries installed. You really can’t get to the bottom of the issue unless you take the lock back to the manufacturer’s stated baseline. How about battery level reporting, how often is it occurring in the log? Maybe there’s an issue that wasn’t found with the lock previously if it wasn’t securely joined before? Is its firmware up to date? What about how it joined? Is it joining Securely now, and perhaps it wasn’t before? The radio has to transmit 3x when paired securely. You reset the lock to join it to a Hubitat correct? That would be a change from before. I am also noticing a few other Zwave devices like leak sensors draining at a rate higher than I've seen before? When I moved from Wink to Hubitat, I did a proper exclusion, and then joined it to the Hubitat Zwave network. I've never had that happen in 3 years with Wink. Twice now in 1 month (once with teh same batteries that ran the lock for 6 months already and now one with new batteries) the lock just shut down and wouldnt respond cause of low power.

What can I do to fix this? Whats the issue here? I enabled Debug Logging to see what the heck is going on, but I am pretty concerned. I was getting 6 - 8 months of battery minimum on this lock with Wink.

SCHLAGE BE469 UPDATE

I've run Zwave Repair as I update and change devices. The hubitat hub itself is about 30ft or so a couple floors up.

SCHLAGE BE469 PRO

There is a Zwave Pro light switch (GE) located right next to it like 12 inches away. I was tied to Wink for years, and I switch to Hubitat. So I have a BE469 that works as well as can be expected, it has FW 7.1 on it.

Schlage be469